Key parameters Key Jumpoff Speed it means the starting (Page 74 / 76) RDWorks V8 Laser Engraving Cutting Software User Manual

Laser Engraving Cutting Software User Manual----RDCAM V8.0

Key parameters

Key Jump-off Speed: it means the starting speed to move the axis by way of the keys on the

keyboard, which can’t be higher than the jump-off speed.

Key Acceleration: it means the acceleration to move this axis by way of the keys on the keyboard,

which can’t be higher than the maximum acceleration of this axis.

Key Reverse: to control the motion direction when move the axis by pressing key manually.

When set the direction polarity parameters correctly, if press the direction key on the panel, the

axis will move to the reverse direction, so enable this item.

4.11.2 Laser parameters

Laser Tube Configuration: single laser and double lasers are available for option and set in

accordance with the laser-tube quantity provided by the manufacturer.

Laser Types: glass tube, RF laser (not need pre-ignition pulse) and RF laser (need pre-ignition

pulse) are available for option.

Laser Attenuation Quotiety

Laser Tube Enable: when there are double laser tubes, user can enable laser 1 and laser 2

respectively.

Maximum Power

Minimum Power

Laser PWM Frequency

Pre-burning Frequency

Pre-burning Pulse width: when the laser is RF laser and need pre-burning pulse, you can

configure the features of pre-burning pulse by pre-burning frequency and pre-burning pulse width.

Water protection enables: When the water protection enabled, the controller must connect the

wiring, otherwise the machine will not emit laser. If disable, no need to connect the water protect

wiring, controller will not test.

Laser PWM Frequency is used to set the pulse frequency of control signal used by the laser, in

general, glass tube is about 20KHZ, RF laser is about 5KHZ; the maximum/minimum power (%)

is used to set the limit power of the laser, that is to say, during running, the maximum power set by

the user which can’t be higher than the maximum power and the minimum power set by the user

which no less than the minimum power. When the laser power is attenuated after using for a time,

then can tune the laser power by the attenuation quotiety; if no attenuation, the attenuation

quotiety is 0.

If it is only provided with the single laser, it will show the one-path parameter.

Prompt

74 / 76